Questions? Give us a call! 847.395.6556|info@mhpgrills.com

GGEIB | ELECTRONIC IGNITOR MODULE

GGEIB | ELECTRONIC IGNITOR MODULE

$29.60

MSRP

FITS: JNR, WNK, TJK Model Grills

SIZE: 1 outlet

SKU: GGEIB

UPC NUMBER: 097524193400

Description

Push button electronic ignitor

  • Single Prong Ignitor
  • Fits JNR4, WNK4 & TJK2 model grills originally fitted with the electronic ignitor

**(1) AAA Battery Required**

Installation

Install the Ignitor

Watch the video below to see how to install an electronic Ignitor (GGEIB)

 


WarningCheck your Ground Wire
. In order for the ignitor to work properly, the ground wire must be in contact with the metal control panel.

GGEIB/GGEIB3 Check ground wire

Maintenance

If you do not hear any clicking when you push the ignitor button, it may be time to replace the battery.

To access the battery, unscrew the ignitor push button and collar. Remove the old battery. If you see any corrosion in the battery compartment it can be removed by wrapping a small piece of sandpaper around the eraser end of a pencil and using that to scrape off the corrosion.

Install a new AAA battery into the battery compartment, positive (+) side down. Replace the push button and collar.

Below is a video showing how to replace the battery in the electronic ignitor.

 

WarningCheck your Ground Wire. In order for the ignitor to work properly, the ground wire must be in contact with the metal control panel.

GGEIB/GGEIB3 Check ground wire

Troubleshooting

Ignitor System

If you experience an occasional “No-spark-no-light” condition here’s a checklist to troubleshoot the problem.

Inspection

    • WITH GAS OFF, position a mirror in front of the collector box and press ignitor button. Observe the condition of the spark. (Low light conditions are the best for seeing the spark.)
      Troubleshooting Ignitor System | Inspect with gas turned off
    • If there’s a good spark, but the grill won’t light, gas may not be flowing to the burner and into the collector box. The gas orifice or the venturi tube may be blocked.
      Troubleshooting Ignitor System | Good Spark

      A good spark will spark at the top

    • If a weak spark arcs down around the ceramic insulator, the insulator should be cleaned. The insulator has a coating grease or it is wet. Use an old toothbrush to break up the conductive electric path.

      Troubleshooting IGnitor System

      A weak spark will arc down around the ceramic insulator

If there is no spark in the collector box

    • Check the wire connections at the ignitor and electrode under the grill.
      Troubleshooting Ignitor System | Check the wire connections
    • Check spark. Pull the connector wire from the collector box. Bring wire to bottom or top of the control panel, hold about 1/8″ away and operate the ignitor. Check for spark. If there is no spark, first replace the battery. If there still isn’t a spark, replace the electric ignitor. If there is a spark the Electric Ignitor is OK, but the Collector Box/Electrode assembly should be replaced (the ceramic insulator could be cracked).
      Troubleshooting Ignitor System | Check spark
    • Make sure ignitor button module is tight on the control panel. If it is loose, a good ground will not be attained.

If the ignitor is not clicking

  • Check or change the ignitor battery
  • Check the ground wire. For the ignitor to work properly, the ground wire must be in contact with the metal control panel.

GGEIB/GGEIB3 Check ground wire

Additional information

OEM #

GGEIB

Size

Go to Top