Step-By-Step Instructions on How to Replace your OBSPH34 Phoenix Burner

How to Replace your OBSPH34 Phoenix Burner

REMOVAL OF OLD BURNER
 
Step 1:
Remove your cooking grid and set aside
OBSPH34 Remove the Cooking Grid
 
Step 2:
Remove your grease bucket and unscrew the drain valve from the end of your drain pipe
OBSPH34 Remove the Drain Valve
Step 3:
Pull your drip pan out from your grill and set aside
OBSPH34 Remove the Drip Pan
Step 4:
Unscrew the (2) wing nuts holding the burner in place located on the underside of your grill
OBSPH34 Unscrew the Wing Nuts
 
Step 5:
Remove the burner & venturi assembly from the inside of the grill using an up and backward motion
OBSPH34 Remove the burner and venturi
 

[/fusion_table]

INSTALLING A NEW BURNER  
Step 1A:
Make sure that burner support pins go through the holes in the bottom of the grill pit
OBSPH34 Burner Support HolesOBSPH34 Remove the burner and venturi
 
Step 1B:
Remove wing nuts & install your new burner & venturi assembly into the grill pit
 
Step 1C:
Making sure the venturi tubes fit over the orifice 1/4″ to 1/2″ (as shown)
OBSPH34 Install over orifice (correct)OBSPH34 Install over orifice (incorrect))
 
Step 2:
Secure the burner in place by screwing the wing nuts to the burner supports located on the underside of the grill pit
 
Step 3:
Reinstall your drip pan
 
Step 4:
Reinstall your drain valve to the drain pipe and hand the grease bucket
 
Step 5:
Replace your cooking grid